Arrived safely and as advertised super fast in usa with fedex. way nicer than sh02 (2 roll) model. silicone dust protected push button full power switch on back which is lighted. proper spring latching tube ports on top and finally angled the correct way to reduce friction, rippled top plastic instead of smooth for less breakage or scratching chance. very nice unit.

All good and working. quick delivery. great dryer for the value.

Great, everything works 👍

It arrived later than expected but in good condition.

All good, good package, fast shipping. inner space for desiccant should be bigger/deeper.

Everything is fine, does what it's supposed to do. Everything is fine.

It operates quite quietly, more so than a single-slot Creality Space Pi. It heats up quickly and seems to be of good quality; perhaps the gate system should be even larger to allow the humidity to drop faster, but it does its job, and it's very important to have it to allow the moisture to escape.

Very good, especially for the possibility of different temperatures and times for each chamber.

Sovol Filament Dryer 4 Spools, with 85℃ Max Temp, Auto Dehumiditification and Sealed Storage, Dual Independent Heating Chambers

Very good, I loved the product, it helped me a lot with the PETG filament. Excellent product, I really recommend it, it's well worth it.

Delivery before the stipulated time, very good product, recommended.

Excellent product, exceeded my expectations! The quality is very good, the workmanship is well done, and everything works perfectly. You can see that it is something well-made.
Another point I really liked was the fast delivery; it arrived before the expected time and was very well packaged. I would definitely buy again and recommend without hesitation!

Quiet and very effective. Delivery to hungary 3 days

The item matches the description exactly and arrived quickly!

All right. working well.
It just didn't drop below 30% relative humidity, even after 8 hours of drying at 50. °

Excellent

Unfortunately, the advertisement did not clearly indicate the voltage of the model to be purchased, and they did not bring the 110V model to Brazil. If you are going to buy, make sure to check the voltage of the product. The store informed me that they only had the 220V model in local stock.

Very well packaged, fast delivery, highly recommended

Very good and quite compact! The manual mentions silica, but it didn't come in the box. To be perfect, it could also have a filament outlet on the back.

This filament dryer works pretty well, it has high temperatures and its solid. However the lid is sometimes a pain to close the latch and the buttons can be wonky such as putting it in auto mode sometimes takes a few tries. Overall i like it but i think the creality might be a better option if you can get it $10-$20 more

The dryer came packaged incredibly well. The instructions are clear and the auto mode is good too (turn on/off automatically based on humidity). It comes with 4 very short ptfe tubes (10cm). You can print straight from the dryer but longer tubes would have been nice for that. It's quite compact compared to what creality and sunlu have to offer as well. It's good for drying 2 different filaments at the same time. It definitely makes some noise but it's not bad. A little louder than my air purifier. The power button wasn't screwed in all the way but it works fine and can easily be fixed. I will have to see how good it is at drying.