Yea this is pretty great just what i needed and shipping was surprisingly fast

Top 👍 delivered very quickly

Sovol 2 Rolls Filament Dehydrator Spool Holder Filaments Dry Box for 1.75mm, 2.85mm ABS PLA PETG TPU FDM Material 3D Printer

and everything is ok. Left as I said. Package intact.

Very good device. Great price for drying 2 filaments simultaneously.

Work fine.
I'm actually surprised on how much.my filament was actually wet... and how much it dryed it in just 8 hours

Sovol 2 Rolls Filament Dehydrator Spool Holder Filaments Dry Box for 1.75mm, 2.85mm ABS PLA PETG TPU FDM Material 3D Printer

Positive Points (Pros):
Active Heating: Incorporates a heater and fan to actively dry the filament, unlike passive dryers.
Double Coil: Can accommodate two 1 kg rolls simultaneously, with inputs to feed directly into the printer.
Touch Screen: Simple controls and a screen to monitor temperature and humidity, although with limited visibility.
Good for Beginners: Easy to use and set up, ideal for those new to filament drying.
Improves Printing: Eliminates moisture, reducing stringing and improving adhesion.
Price: Generally more affordable than other options, offering good value.
Negative Points (Cons):
Fan Noise: The internal fan can be noisy.
Limited Ventilation: Does not expel moisture as efficiently as more expensive models; you need to leave the lid partially open during drying to allow it to vent.
Not airtight (for active drying): Partial opening required

Good value for money. The shipping was very slow.

Great, wonderful.

Pros: very small, easy to use

Cons: fan noise, input power jack is not the universal 5.5x2.1mm barrel jack



I do functional prints using petg and tpu and don't have much space to store filaments, so this small unit works perfectly sitting next to my printer as both a dryer and filament storage. The unit comes with a 12v 4a power supply and plugs into the back but unfortunately the plug isn't a standard 5.5x2.1mm barrel jack (it might be 5.5x2.5 but i'm not sure). The unit shows both the temperature and humidty inside the chamber and the temperature is pretty close to what i measure with a separate thermometer (see picture). The fan has 2 speeds and switches between them when maintaining the temperature, and sounds like a humming noise so i might replace it in the future. But overall i'm extremely pleased to have found this small, inexpensive solution to both dry and store filaments.

Fast delivery, super packed. Everything as described. It's worth the money.

Works well so far. Have used it for several spools with no problems. A little loud but i keep mine in a dedicated printing room, so not a bother for me. If it was next to the bed it would be an issue.

Thank you

everything okay, arrived.

Simple and compact device for 2 coils and affordable too. The product is as described and I can say, after 1 week of use, it's a great device! Thank you.

Item is good. Materials, display, fan is ok.

It comes super protected with a box and packaging and looks very good with plugs, two instructions, I only tested it if it turns on because I haven't had time, later I will add more. For now, good impression of materials.

Came well packaged, a lot of foam for piece of mind. Does what it says. Something too note is that it ranges from 40, 45 and 50 deg c so if using for petg might take a little longer to dry. The power brick feels a bit hot but is probably fine

Impeccable, works well. Could have more temperature settings.

If it works, I'll leave a before and after photo. I'm happy with the purchase 😸